Ericsson winfiol configuration
If the command output window shows CONFIG then the site or the particular sector hardware is working. If the command output window shows BLOCKED then the site is down or not working. Some of the alarms are permanent fault, oml fault, BTS INT affected and so on.īy using this command you can view the radio receiver configuration data to check the particular sector is working, or the site is just about to come. This command is useful to see the active alarms on the site whose TG value is 105.
The command output window has been shown:ĭIP TYPE STATE LOOP TSLOTL DIPEND FAULT SECTION the pcm for the site is not working and the maintenace team needs to find out the fault in the pcm path. If the state in this command output window is ABL then the pcm for the site whose TG no. If the state in this command output window is WO then the pcm for the site whose TG no. It is useful to check the pcm working status of the site. This command is used to view the TG no of a particular site whose site id has been written in the command. In this example I am seeing the status of the site name id sdr001a. This command is used to see the status of all the sites in the network whether the sites are working or not. These commands are very useful to sort out the problem in the 2G mobile bts. I am explaining the commands which are most useful on daily operation and maintenance purpose. It this post I am going to tell you about the ericsson bts 2G commands.